Does it repeat or miss large areas?
Updated on 2024/05/08
(1) If there is a large area in the work that has not been cleaned for the time being, the robot will make up for the leakage autonomously, so don't worry about it;
(2) Sometimes the robot will re-enter the room that has been cleaned, it may not be a repeat cleaning, but only in the autonomous intelligent mending;
(3) be moved or stuck under the conditions, the robot may fail to locate caused by repeated cleaning or missed sweeping, so the cleaning process to minimize human interference and moving (necessary to move not more than 1m from the original position);
(4) When too many items on the ground may be missed, it is recommended to try to put away the ground debris, so that the robot can successfully complete the cleaning;
(5) The bottom of the tables and chairs and benches are easy to trap the robot, causing the robot to mistakenly think that the cleaning is complete, and it is recommended to start sweeping after placing them neatly;
(6) The virtual no-go zone is set too close to the wall/floor items, which will cause the robot to be unable to pass through and lead to leakage of cleaning, so it is recommended to check and adjust it;
(7) The robot will autonomously go back to the base station for charging when the power is lower than 15%; if you turn on the break-point renewed sweeping function, the robot will go to the uncleaned area to continue to complete the cleaning task when the power is sufficient.
(2) Sometimes the robot will re-enter the room that has been cleaned, it may not be a repeat cleaning, but only in the autonomous intelligent mending;
(3) be moved or stuck under the conditions, the robot may fail to locate caused by repeated cleaning or missed sweeping, so the cleaning process to minimize human interference and moving (necessary to move not more than 1m from the original position);
(4) When too many items on the ground may be missed, it is recommended to try to put away the ground debris, so that the robot can successfully complete the cleaning;
(5) The bottom of the tables and chairs and benches are easy to trap the robot, causing the robot to mistakenly think that the cleaning is complete, and it is recommended to start sweeping after placing them neatly;
(6) The virtual no-go zone is set too close to the wall/floor items, which will cause the robot to be unable to pass through and lead to leakage of cleaning, so it is recommended to check and adjust it;
(7) The robot will autonomously go back to the base station for charging when the power is lower than 15%; if you turn on the break-point renewed sweeping function, the robot will go to the uncleaned area to continue to complete the cleaning task when the power is sufficient.